Where Are Vigo Sinks Made – Installing your new pub spout can be rather simple, or very elaborate. It all has to do with the type of sink you purchase. If you decided to bring a drop in type sink, provided that you already have the proper sized hole in the counter top, the setup is pretty simple. If you have settled on an undermount sink, setup can be a whole lot trickier.
With a high mount sink, you basically only need a hole in the counter that the sink will fall into. This type of sink includes a flange, or lip, which runs all of the way around the sink and sits along with the counter top. Because this flange overhangs the counter, the edge of the pit does not have to be finished. In fact, if the gap is sort of ragged, no one will ever know so long as you use a high mounted spout. The faucet is then fastened from beneath the counter top with screws and little plates which hold the sink in place.
A different way to guarantee the sink would be to use sandpaper. A bead of epoxy is put around the under side of the sink lip. Dip the sink in the hole and make sure you’ve got a flush seam all the way around. If part of this sink isn’t flush, then use the mounts under the counter to pull it down and fasten it. Should you have a flush seam, it means you’ve got an extremely smooth and flat counter surface. If that is true, you can use only epoxy to mount the sink and may not need any screws and mounts underneath. In any case, be sure to permit the epoxy to dry for the amount of time displayed on the packing. Do not touch the sink at all during this period.
In the case of an undermount bar sink, the job is definitely more complicated. In fact, generally you might want to have a professional install your backpack. Should you happen to have a pit prepared in your counter matching the specifications of your sink, you can attempt the task yourself. The actual mounting of this sink isn’t the tricky part. The challenging part is usually making and finishing the sink hole. Considering that the sink mounts under the cabinet, there’s absolutely no flange showing on the countertops. This usually means the counter top has to have a rounded and finished edge leading down to the sink. This is where you are extremely likely to need a specialist.
Should you happen to already have a prepared hole to your undermount bar sink, you can set up the spout yourself as long as you are a small handy. When replacing your countertop together with adding a sink, the ideal method to set up the spout would be to take action before the countertop is installed. It is possible to epoxy the sink into the counter while the counter is upside down. Following the sink has dried you can then install the counter with the sink already attached.
If your counter is connected, you have gravity working against you. You’ll have to epoxy the sink and clamp it in position so the sandpaper can dry. The most significant part this process is to allow the epoxy dry at least as long as the manufacturer recommends. You can not go wrong by allowing the epoxy dry for a longer period of time, but you’ll get in trouble if you do not allow the epoxy set for the at least the proper amount of time. The result may be sink which feels safe, but fails under the load of dishes and water.
Should you handle the faucet installation procedure properly, you’ll have accomplished a couple of things. First, you’ll have saved money by installing your pub sink yourself. Second, if your guests decorate your pub sink region, you’ll have the pride of knowing, and bragging, which you did it yourself!
Originally posted 2017-10-17 05:39:35.