Stainless Steel Countertop With Integral Sink – Installing your new bar sink can be fairly simple, or very elaborate. It all has to do with the kind of sink you purchase. If you opted to bring a drop in kind sink, as long as you already have the proper sized hole at the counter top, the installation is pretty simple. When you have decided on an undermount sink, installation can be a whole lot trickier.
With a top mount sink, you basically just need a hole in the counter that the sink will fall into. This sort of sink has a flange, or lip, which runs all the way around the sink and also sits on top of the counter top. Since this flange overhangs the counter, the edge of the pit does not have to be finished. In fact, if the gap is kind of ragged, no one will ever understand so long as you utilize a top mounted sink. The sink is then secured from beneath the counter top with screws and small plates which hold the sink in place.
A different way to secure the sink is to use epoxy. A bead of epoxy is put around the under side of the sink lip. You might even put a bead of glue around the edge of the sink hole. Dip the sink from the hole and make sure you’ve got a flush seam all the way around. If a part of the sink isn’t flush, utilize the mounts under the counter to pull it down and fasten it. If you do have a flush seam, it means you’ve got a very smooth and level counter surface. If this is true, you can use just epoxy to mount the sink and might not need any screws and mounts underneath. In either case, be sure to permit the epoxy to dry for the amount of time shown on the packaging. Don’t touch the sink whatsoever during this period.
In the case of a undermount bar sink, the occupation is definitely more complex. In fact, generally you might want to have a professional set up your backpack. Should you happen to have a pit prepared in your counter fitting the specifications of your sink, you can attempt the job yourself. The actual mounting of the sink isn’t the tricky part. The challenging part is usually making and finishing the sink hole. Considering that the sink mounts under the cabinet, there’s absolutely no flange showing on the countertops. This usually means the counter top has to have a rounded and finished edge leading down to the sink. This is where you are very likely to need a professional.
Should you happen to already have a prepared hole for your undermount bar sink, you can install the sink yourself as long as you are a little handy. When replacing your countertop along with incorporating a sink, the very best way to install the sink is to take action before the countertop is installed. You can glue the sink to the counter while the counter is upside down. Following the sink has dried you can then set up the counter together with the sink already attached.
You’ll need to glue the sink and clamp it in place so the epoxy can dry. The most significant part this process is to let the epoxy dry at least as long as the manufacturer recommends. You can not go wrong by allowing the epoxy dry for a longer time period, but you WILL get in trouble should you not let the epoxy set for the at least the proper amount of time. The outcome may be sink which feels safe, but fails under the load of dishes and water. That’s not a pretty sight, so make certain to let the epoxy dry.
Should you handle the sink installation process correctly, you will have achieved a few things. First, you will have saved money by installing your pub sink yourself. Secondly, if your guests decorate your pub sink area, you will have the pride of understanding, and bragging, which you did it yourself!